<div id="cke_pastebin">
rea-formaldehyde is pervasive. Examples include decorative laminates, textiles, paper, foundry sand molds, wrinkle-resistant fabrics, cotton blends, rayon, corduroy, etc. It is also used as wood glue. UF was commonly used when producing electrical appliances casing e.g. desk lamps. Foams have been used as artificial snow in movies.</div>
<div id="cke_pastebin">
 </div>
<div id="cke_pastebin">
Agricultural use</div>
<div id="cke_pastebin">
Urea-formaldehyde compounds are a widely used as slow-release sources of nitrogen in agriculture. The rate of decomposition into CO2 and NH</div>
<div id="cke_pastebin">
3 depends on the length of the urea-formaldehyde chains and it relies on the action of microbes found naturally in most soils. The activity of these microbes, and the rate of ammonia release, is temperature-dependent. The optimum temperature for microbe activity is around 70–90 °F (21–32 °C).</div>
<div id="cke_pastebin">
 </div>
<div id="cke_pastebin">
Foam insulation</div>
<div id="cke_pastebin">
 </div>
<div id="cke_pastebin">
Urea-formaldehyde insulation</div>
<div id="cke_pastebin">
Urea-formaldehyde foam insulation UFFI commercialisation dates to the 1930s as a synthetic insulation with thermal conductivity of 0.0343 to 0.0373 W/mK.</div>
<div>
 </div>
<div id="cke_pastebin">
UFFI is a foam with similar consistency to shaving cream, that is easily injected or pumped into voids. It is normally made on site using a pump set and hose with a mixing gun to mix the foaming agent, resin, and compressed air. The fully expanded foam is pumped into areas in need of insulation. It becomes firm within minutes, but cures within a week. UFFI is generally found in homes built or retrofitted from the 1930s to the 1970s, often in basements, wall cavities, crawl spaces and attics. Visually, it looks like oozing liquid that has been hardened. Over time, it tends to vary in shades of butterscotch, but new UFFI is a light yellow colour. Early forms of UFFI tended to shrink significantly. Modern UF insulation with updated catalysts and foaming technology have reduced shrinkage to minimal levels (between 2 and 4%). The foam dries with a dull matte colour with no shine. When cured, it often has a dry and crumbly texture.</div>